Zeal International

With refrigeration system and micro-processor based digital temperature controller. Ductility is defined as distance in cm to which a standard briquette of bitumen can be stretched before the thread breaks. The briquette is stretched at a rate of 50 mm/min. ± 2.5mm per minute at a temperature of 27°c ± 0.5°C. The machine is having built in refrigeration system to work a below ambient temperature up to 8°C in tropical conditions. The machine will operate at 27°C with control accuracy of ± 0.5°C as per the requirement of IS. The apparatus consists of water bath with a heater, and a circulating pump to maintain uniform water temperature. One half of the briquette moulds is fixed in a fixed plate in the water bath, the other half of the briquette mould is fixed to a carrier which slides over a rotating threaded shaft with a clutch, the motor and gears to rotate the shaft are housed in a cabinet fixed above the other end of the bath. A pointer fixed to the carrier moves over. A scale graduated from 0-100 cm x 1mm fixed on the bath with "0" (zero) of the scale towards the fixed plates side. The rotating shaft has 2 speeds of travel for the bracket, 5 cm/min. And 1cm/min.Selected by a clutch. Water bath inside is of stainless steel with insulation and water drain cock. A heater with is fitted inside the water bath. The temperature is controlled by dual display microprocessor based auto tuning PID digital temp. Indicator cum controller. Control switches for motor, stirrer, heater and indicator lamps are fixed at a convenient place on the water bath. Complete with three briquette moulds and one base plate, all supply single phase. As per IS1208.

This apparatus is used to determine Softening point of Bitumen. It is that temperature at which a sample of bituminous material loaded by steel ball, drops a specified distance when heated under specified conditions. The apparatus consists of steel bracket with a sliding plate support. That support has two holes of 10mm dia on which a ring and ball guide can be kept. A central hole on this plate is for inserting thermometer. Supplied with a glass beaker, high and a hand stirrer and 2 Nos. 9.5mm dia steel balls

The apparatus consists of a heavy gauge shield, lagged with asbestos cover in two parts and wire gauge. The shield is supported on a platform with chimney arranged for fitting to stand. Complete with one distillation flask of 500 ml and one 100 ml crow receiver but without thermometer. Electric hot plate heated with energy regulator.

For determining the temperature at which a sample of bituminous material loaded by a steel ball, drops a specified distance when heated under specified conditions. The new design of Ring and Ball Apparatus is compact user friendly and has better aesthetics. It has magnetic stirrer with heating facility and digital display of temperature, the heating can be adjusted through knob.

Each unit is supplied with a bath of heat resistant glass and the following:

• ZI 4003-A: Tapered Rings 2 Nos.
• ZI 4003-B: Ball Centering Guide 2 Nos.
• ZI 4003-C: Steel Balls of 9.5 mm dia 2 Nos.
• ZI 4003-D: Ring Holder 1 No.
• ZI 4003-E: Electric Heater (Hot Plate) 1 Nos